BibTeX:

@article{IJIRSTV1I10090,
     title={FEM Simulation of Impact of Round Tool on Composite Laminated Block},
     author={Suman Anand, Sharad Shrivastava, Himanshu Singh Rathore, Chandra Mohan Kumar and Sunil Kumar},
     journal={International Journal for Innovative Research in Science & Technology},
     volume={1},
     number={10},
     pages={242--251},
     year={},
     url={http://www.ijirst.org/articles/IJIRSTV1I10090.pdf},
     publisher={IJIRST (International Journal for Innovative Research in Science & Technology)},
}

Many industries like Aviation sector, War and general purpose Helmet making industries, War equipment industries use high velocity impact analysis for design purposes .It is very difficult to analyze by experimental set up because of high costing of experimentation and technical limitations of experiments like high velocity cameras, velocity measurement instruments etc, while the use of computer simulation software like Ansys help researchers to analyze these type of problems very easily.The failure of an alloy of AL6061-T6 with composite laminated plates Kevlar-29 and E-Glass are analyzed under high-velocity impact of round tool of structural Steel using the FEM software, ANSYS Workbench 14.5.Two impact velocities of 500 m/s and 700 m/s were analyzed by FEM simulation . It was analyzed that metal alloy of AL6061-T6 is more resistant than various combination of layers of composite plates, only use of combination of composite materials can not be sufficient for overall strength of laminated plate so use of metal alloy is good approach to increase the strength. It was also observed that mass of tool and overall tool dimension play an important role to failure of composite laminated block plate. In this analysis plate thickness was kept constant but combination of plate layer were changed.

Ansys Workbench 14.5, FEM Analysis, AL6061-T6, Kevlar-29, E-Glass